Toolbars

This section lists the commands available in the Logical 3D Architecture workbench toolbars.

The Logical 3D Architecture workbench has its own set of toolbars. There are two types of these toolbars; visible toolbars located on the right and at the top in the default set-up and contextual toolbars which appear in some commands.

Compass Toolbar

This section lists the commands in the West Compass.

Box

See Creating a Shape and Logical Component
Cylinder

See Creating a Shape and Logical Component
Sphere

See Creating a Shape and Logical Component
3D Shape

See Creating a Shape and Logical Component
Create Pathway

See Pathways

Snap Toolbar

This section lists the commands in the Snap toolbar. You can use snap capabilities for more control over routing.

Toggle Snap

See Using Snap Capabilities

See Snap Mode Sub-toolbar

Snap Mode Sub-toolbar

Snap to Step

See Using Snap Capabilities
Snap Off Last Position

See Using Snap Capabilities
Snap Relative to Plane

See Using Snap Capabilities

Measure Toolbar

This section lists the commands in the Measure toolbar. You can use the measure tools to determine the dimensions, areas, volumes, etc. of logical objects and the distance (minimum, maximum, etc. ) between them.



Measure Item

See Measure an Object
Measure Between

See Measure Between Objects

Automatic Routing Toolbar

This section lists the commands in the Automatic Routing toolbar. You can use the automatic routing tool to route the route components of a large logical system.



Automatic Routing

See Routing using Logical 3D Architecture Workbench