View Name Definition

You can customize the view name using the following parameters:

Automatic: Available values are:
- Yes: The Name is automatically managed. It corresponds to the string associated to the View Type.
- No: The Name follows the standard file definition. It corresponds to the Name parameter that is used.
Name: When Automatic parameter is set to No, it is used to fill the Name character string which is part of the View Name. If it is empty, the Name will be empty too.

The following table lists all the parameters available in the standard to customize the Name, as well as the default value, depending on its standard:

View Type	Parameter	ISO	JIS	ASME
Front	Automatic	Yes	Yes	Yes
Front	Name
Left	Automatic	Yes	Yes	Yes
Left	Name
Right	Automatic	Yes	Yes	Yes
Right	Name
Top	Automatic	Yes	Yes	Yes
Top	Name
Bottom	Automatic	Yes	Yes	Yes
Bottom	Name
Rear	Automatic	Yes	Yes	Yes
Rear	Name
Auxiliary	Automatic	No	No	Yes
Auxiliary	Name
Section	Automatic	No	No	Yes
Section	Name
Section Cut	Automatic	No	No	Yes
Section Cut	Name
Detail	Automatic	No	No	Yes
Detail	Name
Isometric	Automatic	Yes	Yes	Yes
Isometric	Name
Axonometric	Automatic	Yes	Yes	Yes
Axonometric	Name
Unfolded	Automatic	Yes	Yes	Yes
Unfolded	Name