Using the Place Mode (Z only)

The Place Mode (Z only) only moves the manikin in the vertical, direction, that is, following the world z-axis, still in accordance with its referential.

Before you begin: Have a manikin, and a object in your scenario.
  • Click Place Mode (Z only).

    Note: Once the Place Mode is activated, if you manually change the compass position (i.e. handling the compass by grabbing its central red dot), the selected manikin is snapped at the new compass position, in accordance with the manikin's referential. This applies to both Place Mode commands. Any further move of the compass has an effect on the last selected manikin.

    Follow the same steps for Using the Place Mode