More about Creating a Cutout

Confusion in Case of Overlaps

Specifying the support for the cutout avoid confusions in case of overlaps.

For instance, if you try to create a cutout on the representation below, a warning message is displayed.

To avoid this, you have to select the exact support for the cutout.

Here are presented the pocket cutouts you can create.

You can create the following cutouts:

Pocket Cutout on a Standard Cutout

Pocket Cutout on a Pocket Cutout

Pocket Cutout Impacting One or Multi Planar Faces and Cylindrical Bends. Before the Cutout

Pocket Cutout Impacting One or Multi Planar Faces and Cylindrical Bends. After the Cutout

Pocket Cutout on a Standard Stamp (Generative Sheetmetal Design)