Units

Units

The default unit along with its symbol is displayed for each magnitude. You can define or redefine:

• the default unit
• and the display of values for magnitude type parameters.

Dimensions display

Note that this option is available only if the XML configuration setting is set.

Warning: These settings will not be taken into account if the computed value is comprised between -0.5 and +0.5.

Display trailing zeros

If checked, enables you to display trailing zeros.

Exponential notation for values greater than 10e+

Enables you to define the upper limit for using an exponential notation.

By default, this option is set to 6.

Exponential notation for values lower than 10e-

Enables you to define the lower limit for using an exponential notation.

By default, this option is set to 6.

Same display for read/write numbers and read-only numbers

If checked, both read-write and read-only numbers will have the same display.

Important: If you specify a number of decimal places greater than 8 the computed value will not be rounded-up.

By default, this option is checked.

Decimal places for read-write numbers

Enables you to define the number of decimal places to display for read-write numbers.

By default, this option is set to 3.

Decimal places for read-only numbers

Enables you to define the number of decimal places to display for read-only numbers.

By default, this option is set to 3.