Specification

- Standard Specification
- Clash and contact
-
By default,
this option is selected.
- Clearance
- Computes clearance during simulation.
- Clearance Value
- Specify the minimum clearance value.
- Activate Engineering connection specification
- By activating this, the specifications for simulating the interference are taken from the Engineering Connection interference check options.
-
-
- Check No Clash
- An interference result is generated only if the clashes are identified.
- Check Contact
- An interference result is generated only if the contact are identified.
- Check Clearance
- An interference result is generated only if the clearance between two component is less that the specified minimum clearance.
- No Check
- No interference result is generated.
- Compute quantifier
- Computes and store the clearance minimal distance. This value will
appear in the interference simulation result, in the Quantifier
column.
Note:
This option reduces the simulation speed.
- Recompute only modified interferences
- Reuses existing interference simulation results when updating the
interference simulation.
Note:
Results are reused only when
recomputing the same interference simulation.
|