Wires |
Wire reference products
|
Imported
|
Wire group reference products
|
Imported
|
Devices |
Electrical behavior added to reference parts
|
Imported |
Electrical behavior added to reference products, except splices
(see below)
|
Not imported; only reference parts are considered electrical
devices.
V5 electrified products are imported as geometry.
Workaround: Run the command in V6 after importing splices.
|
Splice reference product
|
Imported Splice attributes (Length and Equivalence thickness)
are imported. |
Electrical behavior added to part instances
|
Not imported; only reference parts are considered electrical
devices.
|
Connection points
|
All connection points, except terminations
|
Imported
|
Terminations
|
Imported as cavities.
Note:
Terminations on Contacts are not imported, as a Cavity is not
allowed on Contact.
See Electrical Library > Adding Connection Points > Adding a Cavity.
|
Reference retainer parts
|
Reference support parts
|
Imported
when the supports are created or edited after V5R17. |
Reference retainer parts
|
Imported |
Reference adapter parts
|
Imported as regular (non-adaptative) supports.
|
Protective coverings
|
Reference parts
|
Imported as features in the branch.
|
External protective covering is the reference of a CATPart
|
Not imported.
Workaround: Run the
command in V6 after importing external protective coverings.
Therefore, external protective coverings that cover more than one
branch are migrated. Only the V5 internal protective coverings are
also handled since they cannot cover more than one branch. At the
end of the post-process:
- Temporary external protective coverings of Mechanical Product
type will be deleted.
- External protective covering is converted into 2 internal V6
protective coverings.
|
Internal protective covering is the reference of a CATProduct. It
is aggregated under the body Protections in the part of a
multibranchable.
|
Imported.
|
Regular protective covering attributes
|
Imported as protective coverings.
See Importing Electrical Data.
|
Adjust relation on regular protective coverings
|
Not imported
|
Light protective coverings (V5R18 onwards) and Adjust
relation between them
|
Imported |
External tape can cover more than one branch and is adjusted to the
segment with the maximum diameter of all segments covered
|
Imported. An external tape is imported in each internal tape
protection that exist. Since these protections are independent from
each other, they will be adjusted to the segment with the maximum
diameter on the branch they cover. All segments are covered by the
original external tape.
Similarly, if the V5 external tape is covered by another
protection, its V6 internal protections will be adjusted to the
same protection, if it is located under the same harness bundle.
|
Elec_Text attribute on Protective Coverings
|
Imported |
Instances |
Instances of reference parts where electrical behavior added to
reference part
|
Imported; reference designator replaced by instance name.
|
Instances of reference products containing instances of reference
parts
|
Partially imported.
Reference designator to instance name mapping when within an
assembly may lead to loss of information because instance names are
unique within the assembly only.
|
Splice instance
|
Link between splice and end of segment is imported.
Splice position is imported. |
Electrical connections |
Between devices that are geometrically connected with mechanical
constraint
|
Imported |
Between devices that are not geometrically connected |
Imported but the electrical link is lost.
|