Constructing a Filter

This task explains how to construct a filter.

Before you begin: You must be in one of the filtering interfaces:


  • Catalog Filter of the Catalog Editor

  • Filter Assistant of the Browser and the Immersive Browser

  1. In the first list of a given row, choose a keyword.

  2. In the second list of the same row, choose an operator.

  3. In the third list of the same row, choose a value (note: the value can also be entered manually).

    Tip: When you create a filter using the AND operator, only values that are valid according to defined conditions will be available for selection. However, when the OR operator is used or if you are modifying a filter, then all values will be available for selection.

  4. To activate the condition (row), click .

  5. To deactivate a condition, click the associated check button on the left-hand side of the row.

    Warning: You should only click the check button to deactivate an active condition. (Use Tab to activate a condition once its operator and operand have been defined.)

  6. To remove a condition, click .

  7. To remove all conditions of the currently defined filter, click Clear .

    The filter content is cleared.

  8. To designate the operator, select AND or OR (the selected operator is applied between all conditions of the constructed filter).



    Tip: Click Assisted Mode Activated (the mode will then switch to Edit Mode Activated) to be able to modify the constructed filter by typing directly in the box.